This page assumes you’ve already read our full Dishwasher Not Draining guide. Everything below is specific to Frigidaire’s reset procedure, part locations, and error behavior. If you’ve worked through the checks and it’s still not draining, our no-blockage follow-up guide covers the pump itself.
Frigidaire reset procedure
Press and hold Start/Cancel for 3 to 5 seconds to clear the current cycle. If the dishwasher stays unresponsive, cut power at the breaker for 5 minutes, Frigidaire’s control boards generally need the longer window to fully reset.
Where the filter and pump are on Frigidaire dishwashers
On self-cleaning models, there’s no filter cylinder to remove, check instead for a jam by shining a flashlight into the drain area at the bottom of the tub, looking for glass or bone fragments caught in the chopper. On the newer manual-filter models, the filter twists out of the tub floor the same way as most other brands. On both types, the pump is mounted low at the front, accessible after removing the toe kick panel and a few screws, more involved than a filter check but manageable without pulling the unit out.
Error codes you might see
PF just means the dishwasher lost power mid-cycle and will resume where it left off, which can look like a stalled drain even though nothing is actually clogged. Many Frigidaire models don’t display a dedicated drain-fault code at all; instead, a blinking light pattern signals the fault, so check your use and care guide to decode it rather than expecting text.
Known Frigidaire pain points
People with a self-cleaning model sometimes go looking for a filter that doesn’t exist and waste time trying to pry open the tub floor. If your model has no visible filter cylinder, skip straight to checking the drain hose and chopper area instead. A PF code after a storm or power blip doesn’t mean anything is broken, run the reset first before assuming a part failed.
Frequently Asked Questions
Does my Frigidaire dishwasher have a filter?
Most models don't, they use a self-cleaning macerating system instead. Check your model's spec sheet if you're unsure, since some newer models do have a manual filter.
Is PF a sign of a broken part?
No, it just means the cycle was interrupted by a power loss. Reset and restart before assuming anything is damaged.
How do I check for a clog with no filter to remove?
Shine a flashlight into the drain area at the tub floor and look for debris caught in the chopper blade.
How do I reach the pump on a Frigidaire dishwasher?
Remove the toe kick panel at the front-bottom of the unit; the pump is accessible from there on most models.
The information provided here is a diagnostic aid and does not replace the intervention of a qualified professional.
]]>