All problems
Chaque fiche hiérarchise les causes probables et indique clairement quand il faut s’arrêter.
Examples: not draining E15 leak not heating
-
Samsung Microwave Not Heating? The Demo Mode Timer Test
Samsung’s own troubleshooting includes a specific test: if the countdown timer runs faster than it should, the microwave is in Demo mode, not actually broken.
-
GE Microwave Not Heating? Why GE Skips DIY Advice on This One
GE’s own support material offers no repair steps beyond two checks, tied to the same capacitor shock hazard behind most microwave repairs.
-
Microwave Turntable Not Turning? 3 Causes Ranked by Likelihood
Food debris under the glass tray causes most stuck turntables. Cleaning the roller guide fixes the majority of cases before you need to replace any part.
-
Microwave Sparking or Arcing Inside? Causes and When to Stop Using It
Sparking almost always traces back to metal inside the cavity or a grease-soaked waveguide cover, not a failing magnetron. Both are quick, safe fixes.
-
Microwave Not Heating? 7 Causes Ranked by Likelihood (With Tests)
If the light, turntable, and fan still run but food stays cold, the problem is almost always Demo Mode, a door switch, or the diode, not the magnetron.
-
Keurig Leaking Water? 6 Causes Ranked by Likelihood (With Tests)
Nine times out of ten it’s an overfilled reservoir, a blocked valve at its base, or a full drip tray mistaken for a leak, not a cracked machine.
-
Keurig Not Brewing? 6 Causes Ranked by Likelihood (With Tests)
Nine times out of ten it’s an air lock in the lines, a reservoir that isn’t seated, or a clogged needle, not a dead pump. Check these before assuming the worst.
-
Keurig Descale Light Won’t Turn Off? 5 Causes Ranked by Likelihood (With Tests)
Nine times out of ten the descale cycle wasn’t run to completion or the rinse wasn’t thorough enough. Here’s what actually clears it, in the order most likely to work.
-
Keurig Won’t Turn On or Not Working? 7 Causes Ranked by Likelihood (With Tests)
Most of the time it’s not plugged in fully, a tripped GFCI outlet, or a water reservoir that isn’t seated all the way. Check all three before assuming the machine is dead.
