F7 E1 means the motor cannot reach the correct speed for the selected cycle. Whirlpool’s own checklist looks at installation and load size before anything mechanical.
Brand: Whirlpool
Whirlpool Washer Error Code F7 E1 (Motor Speed Error)
F7 E1 signals a motor speed sensing error, most often because shipping bolts were left in place or the load is too heavy.
Meaning
Possible causes
No cause is certain until it has been checked on the appliance.
- Likely Shipping bolts not removed after a new installation
- Possible Washer overloaded for the selected cycle
- Rare Motor or drive component fault
First checks
- Confirm all shipping bolts were removed if the washer was recently installed or moved.
- Reduce the load size and try a shorter cycle.
- Press Pause or Cancel twice, then Power once, to clear the code and retry.
What not to do
- Running large, heavy loads such as rugs or bedding on repeat while this code is active.
An error code varies by brand
The same code can have a different meaning depending on the brand and model. Always check your appliance's manual before acting.
Related problems
- Low
Washing Machine Won’t Start? 6 Causes Ranked by Likelihood (With Tests)
Most washers that won't start have a door that isn't fully closed, a tripped breaker, or an engaged control lock, rarely a…
- Low
Washing Machine Stuck on Spin Cycle? 6 Causes Ranked by Likelihood
A washer stuck on spin is usually re-attempting because of an unbalanced load or an unconfirmed lid/door switch, rarely a failed motor.
- Low
LG Washing Machine Not Draining: Reset, Filter Location & Error Codes
LG front-load washers have a pump filter behind a small hinged door at the bottom front, very similar to Samsung's layout. The…
Related guides
When to call a professional
If the simple checks didn’t solve it, if the fix involves electrical wiring, gas, or the refrigerant circuit, or if you have any doubt at all: stop there and hand the appliance to a qualified repair professional.