Marque :Brand:

Whirlpool Washer Error Code F22 (Motor Communication Error)

F22 means the control board lost communication with the motor, usually a loose or corroded connector rather than a motor failure.

Risk: Moderate

Meaning

F22 appears when the power board can no longer communicate properly with the motor. It’s often a simple connection issue rather than a motor failure.

The information provided here is a diagnostic aid and does not replace the intervention of a qualified professional.

Possible causes

No cause is certain until it has been checked on the appliance.

Likely Connector between board and motor unplugged or corroded
Possible Damaged wiring between board and motor
Rare Failed control board or motor

Tools needed

Screwdriver
Flashlight
Multimeter

First checks

Unplug the washer for 10 minutes, then plug it back in to reset the electronics.
Check all connectors between the power board and the motor.
Inspect the wiring for a cut or bare wire.

Step-by-step diagnosis

Unplug the washer for a full ten minutes. Pressing Off is not the same thing, the board has to lose power.
Plug back in and run a short cycle. An F22 caused by an electrical glitch does not come back.
If it does return, unplug again and take off the rear panel.
Work through the connectors between the power board and the motor one at a time: unplug, check for corrosion, push back until they click.
Follow the harness along its length looking for a rub point against the chassis. That is where insulation wears through.
On a brushed motor, check the brush length. Worn down to the spring, they cause intermittent dropouts that look exactly like a communication fault.

What not to do

Removing the control board before checking the connectors first.
Replacing the motor outright — F22 is a communication fault, not proof the motor itself has failed.

When to stop

Connectors and harness are sound and the code stands. That leaves the board or the motor, and diagnosing those is a service job.
There is scorching or a darkened track visible on the power board.

An error code varies by brand

The same code can have a different meaning depending on the brand and model. Always check your appliance's manual before acting.

Related guides

When to call a professional

If the simple checks turned up nothing, if the repair involves electricity, gas, or the sealed refrigerant system, or if you have any doubt at all: stop there and hand the appliance over to a qualified technician.